Navigate to Settings > Microphones > System Mic 1
The input processing section has a bookmark icon which allows a press to be stored capturing both EQ and Compressor.
Set the processing to the desired settings. Tap/click the bookmark icon in the top right hand corner.
Create a preset for these settings. The subtitle shows the scope of the preset - i.e. what is being stored.
Return to the Routines section of WebApp.
Where it is possible to apply a preset to a different input source or channel, the selection list offers the choice of source or output on which to apply the preset.
The preset that has just been created "Dynamic mic" can now be applied to any or all of the microphones by selecting it from the drop-down list, including those for the Zones.
The selected preset can be cleared back to a "do nothing" state with the X button. The full list of System Preset scopes which can be recalled from Routines is as follows:
Per Music source presets:
- Music Source Input EQ
Per Microphone presets:
- Microphone EQ and Compression
- Microphone Zone Levels
Per zone presets:
- Zone Microphone EQ and Compression
- Zone Music Source Input EQ
- Zone Ducker
- Zone Fader Min/Max
Per line output:
- Source
- Speaker preset (EQ and Crossover)
- User EQ, Trim and Delay
Per Amp output (Zone 4P and Zone 8P only):
- Source
- Speaker preset (EQ and Crossover)
- User EQ, Trim and Delay
Brightness:
- ZonePads
- Zone front panel