There are three amplifiers in the Amp range:
Amp 100
Two channels of Class A/B amplification, 350W per channel at 4Ω, 250W per channel at 8Ω and 700W Bridged at 8Ω
Amp 200
Two channels of Class A/B amplification, 700W per channel at 4Ω, 400W per channel at 8Ω and 1400W Bridged at 8Ω
Amp 300
Two channels of Class A/B amplification, 1350W per channel at 4Ω, 800W per channel at 8Ω and 2700W Bridged at 8Ω
All models in the Amp range feature identical rear panel layouts. In put signal can be direct from an Optimal Audio Zone controller, or a line signal from an external source.
- If using with a Zone controller make sure the rear panel gain switch is depressed in 'Zone' position. If using with another source set to ' 32dB' position
- Input is via valanced or unbalanced XLR or 1/4" TRS Jack connector
- Select the operation mode STEREO-BRIDGE-PARALLEL
- Connect amplifier outputs to loudspeakers via speakON® or binding post. Refer to the diagrams, found in Amp - Loudspeaker Outputs, or information on the Amp rear panel for the correct wiring
- Once you have connected everything up, plug your Amp into the mains power and turn it on
- Turn the relevant amplifier channel volume knob on the front panel all the way up
- Green LED's will illuminate on the channels to which signal is applied. These will illuminate Red if the amplifier is in clip