Note - Do not plug ZonePad into Zone when the power is on
ZonePad 1 is connected to the Zone via CAT 5/6 cable. On the rear of Zone 4 and Zone 4P you will find four RJ45 connections labelled 'Wall Controller Inputs', and below they are numbered 1,2,3,4.
If you are using ZonePad 1 with Zone 8 or Zone 8P the same applies, but there are eight Wall Controller Inputs numbered 1,2,3,4,5,6,7,8.
ZonePad 1 can control a single zone and must be connected to the port that corresponds to the zone in which it is located. For instance, if you have a ZonePad 1 in the Bar, and you have set up Bar as zone 1 in WebApp, connect ZonePad 1 to Wall Controller Input 1.